HOME
About JTHOOPITUP
HOW-TO VIDEOS
PHOTO GALLERY
USER GUIDES
More
0
Floating a Onesie / Baby Tee
(
Hover Mouse Over Each Picture
)
5x7 JTH, 5x7 Frame, Accy's, and Onsie
Your Supplies
For some machines the design will need to be rotated 180 degrees
Marking the center of the design
Move your needle to the top of the design and mark
Draw line to indicate top of the design (reminds you design is rotated). Then move to the bottom of the design and mark
Connecting the dots you marked on the stabilizer
Nice, straight centerline
Where the top of the design will be (at the bottom of the hoop). Note that the hoop is rotated
Using a paper printout of the design for placement, mark the top of the design
Finding the center of the Onesie
Draw a center line down the Onesie
A nice straight line for placement
Spray the stabilizer around the edge of the inner frame
It is important to spray around the inside inner ring all the way around, and lightly in the middle
Your marked Onesie
Turn the Onesie inside out
This Onesie is a 6 Mo
Find the top mark you placed on the Onesie
Matching the placement
mark on the Onesie with the placement mark on the Stabilizer
Matching the line on the Onesie with the line on the Stabilizer
Smooth the Onesie on the stabilizer all the way to the edge of the frame where the spray adhesive was applied
Curved part (Head) of the JTHOOPITUP.....
Insert the Head of the JTH into the Onesie.
The Head of the JTHOOPITUP comes up through and out the neck of the Onesie
Roll up the bottom of the Onesie to the bottom edge (Foot) of the JTHOOPITUP
Clip the bottom of the Onesie to the JTHOOPITUP
Place clips far apart
Place one hand inside of the Onesie holding the JTHOOPITUP
Gently pull the bottom of the Onesie over the Head of the JTHOOPITUP.
Take your velcro straps.....
Insert the straps through the neck of the Onesie attaching to the Head of the JTH
Clips and Velcro Straps secure the JTHOOPITUP to the Onesie
Show More
Nice, straight centerline