5x7 JTH, 5x7 Frame, Accy's, and Onsie

Your Supplies

For some machines the design will need to be rotated 180 degrees

Marking the center of the design

Move your needle to the top of the design and mark

Draw line to indicate top of the design (reminds you design is rotated). Then move to the bottom of the design and mark

Connecting the dots you marked on the stabilizer

Nice, straight centerline

Where the top of the design will be (at the bottom of the hoop). Note that the hoop is rotated

Using a paper printout of the design for placement, mark the top of the design

Finding the center of the Onesie

Draw a center line down the Onesie

A nice straight line for placement

Spray the stabilizer around the edge of the inner frame

It is important to spray around the inside inner ring all the way around, and lightly in the middle

Your marked Onesie

Turn the Onesie inside out

This Onesie is a 6 Mo

Find the top mark you placed on the Onesie

Matching the placement
mark on the Onesie with the placement mark on the Stabilizer

Matching the line on the Onesie with the line on the Stabilizer

Smooth the Onesie on the stabilizer all the way to the edge of the frame where the spray adhesive was applied

Curved part (Head) of the JTHOOPITUP.....

Insert the Head of the JTH into the Onesie.

The Head of the JTHOOPITUP comes up through and out the neck of the Onesie

Roll up the bottom of the Onesie to the bottom edge (Foot) of the JTHOOPITUP

Clip the bottom of the Onesie to the JTHOOPITUP

Place clips far apart

Place one hand inside of the Onesie holding the JTHOOPITUP

Gently pull the bottom of the Onesie over the Head of the JTHOOPITUP.

Take your velcro straps.....

Insert the straps through the neck of the Onesie attaching to the Head of the JTH

Clips and Velcro Straps secure the JTHOOPITUP to the Onesie